A.1
B.2
C.3
D.4
E.5
F.6

A.MPLS TE
B.MPLS VPN
C.When CEF switching and Label switching is done
D.In all the above circumstances

A.Lightweight messaging
B.Memory management
C.Hardware abstraction
D.Host stack
E.Process scheduling
F.All of the above

A.Filter Smurf ICMP packets.
B.Filter as close to the core as possible
C.Filter as close to the edge as possible
D.Filter as precisely as possible
E.Filter both source and destination where possible

A.Two LSAs will exist in the network for this destination， and both will be used
B.Two LSAs will exist in the network for this destination， but only the one generated by the highest RID ASBR will be used
C.Only the LSA generated by the highest RID ASBR will exist in the network
D.Only the LSA generated by the lowest RID ASBR will exist in the network

A.standby 1 priority 110
B.standby 1 priority 120
C.standby 1 priority 130
D.standby 1 priority 110 preempt
E.standby 1 priority 120 preempt
F.standby 1 priority 130 preempt

A.A sham-link is created between any twoo VPN sites that belong to the same OSPF area and share an OSPF backdoor link
B.A sham-link is seen as an intra-area link between PE routers，an OSPF adjacency is created and data base is exchanged
C.A SHAM link is created between two directly connected PE routers so that it is preferred over the low speed backdoor door
D.A SHAM link is part of OSPF network of MPLS-VPN provider

A.AS numbers are assigned by the IANA
B.AS numbers are used by BGP （Border Gateway protocol ） to exchange IP routing information with neighboring AS
C.In the internet， an Autonomous System （AS） is a collection of IP networks and routers under the control
D.All of the Above

A.show tag-switching tdp binding 1.1.1.0/24
B.show tag-switching tdp bindings neighbor 1.1.1.0
C.show tag-switching interface e0/0
D.A and B both will show the binding.
E.All of the above.

A.LLQ supports the addition of strict priority queuing
B.With LLQ， bandwidth allocations for the priority queue and all the CBWFQ queues areconfigured using the priority command
C.LLQ is configured using MQC and CBWFQ is configured using the fair-queue command
D.LLQ priority queue bandwidth is policed with a congestion aware policer
E.LLQ does not support WFQ on the default traffic class （class-default）