A.The MDT group address should be the same for both address families in the same VRF
B.The MDT group address should be the same for both address families in the different VRFs
C.Configuration of the MDT source on a pre-VRF basis is supported only on IPv6
D.The MDT group address should be different for both address families in the same VRF
您可能感興趣的試卷
你可能感興趣的試題
A.GRE tunnels
B.automatic 6 to 4 tunnels
C.ISATAP tunnels
D.manual tunnels (RFC 2893)
A.MPLS is enabled on the core, distribution, and edge devices.
B.A triple stack is enabled on PE devices.
C.The network has at least six PE devices.
D.A dual stack is enabled on all the P and PE devices in a network.
A.IPv4 packets are carried over IPv6 tunnels to the LSN while IPv6 traffic is forwarded natively.
B.Ipv6 packets are carried over IPv4 tunnels to the LSN while IPv4 traffic is forwards natively.
C.The LSN performs NAT44 on private IPv4 source addresses.
D.DS-Lite does not perform any address translation.
A.interface Ethernet0/0 I.pv6 traffic-filter NoULA out I.pv6 access-list NoULA Deny ipv6 FC00::/8 any Permit ipv6 any any
B.interface Ethernet0/0 I.pv6 traffic-filter NoULA out I.pv6 access-list NoULA Deny ipv6 FC00::/7 anyP ermit ipv8 any any
C.interface Ethernet0/0 I.pv6 access-group NoULA out I.pv6 access-list NoULA Deny ipv6 FC00::/8 anyP ermit ipv6 any any
D.interface Ethernet0/0 I.pv6 access-group NoULA out I.pv6 access-list NoULA Deny ipv6 FC00::/7 any Permit ipv6 any any
A.all link-local addresses
B.all IPv6 prefix and topology information that OSPFv2 included in Router LSA and Network LSA
C.list of options associated with the link to all other routers attached to the link
D.all prefix-specific information that OSPFv2 included in Router LSA and Network LSA
A.6PE feature is supported over tunnels other than RSVP-TE tunnels
B.Core MPLS routers are supporting IPv6 ONLY
C.6PE feature is not supported over tunnels other than RSVP-TE tunnels
D.Core MPLS routers are supporting IPv4 only
A.The virtual routing and forwarding table is separate from the global routing table that exists on PE routers. Routes are injected into the VRF from the CE-PE routing protocols for that VRF and any MP-BGP announcements that match the defined VRF RTs
B.Multiprotocol Border Gateway Protocol is run between PE and CE routers to exchange customer prefixes in a VPNv4 format
C.A customer edge router peers at Layer 3 to the provider edge. The PE-CE interface runs either a dynamic routing protocol (eBGP, RIPv2, EIGRP, OSPF) or a static routing protocol (Static, Connected)
D.VPNv4 address is the combination of the RT and customer IPv4 prefix. These VPNv4 prefixes are passed in MP-BGP
A.EVC infrastructure is a Layer 3 platform-independent routing architecture that supports IP overEthernet services
B.Ethernet flow point (EFP) is configured on the main interface
C.Feature commands like MQC-based QoS policies can be specified
D.EVC infrastructure is a Layer 2 platform-independent bridging architecture that supports Ethernetservices
E.Each Ethernet flow point (EFP) matches a predefined VLAN tag-based criteria
F.Ethernet flow point (EFP) is configured on the VLAN interface
A.CSNP
B.LSP
C.ISH
D.Hello
E.IIH
F.PSNP
A.Show mpls Idp neighbor detail
B.Show mpls Idp bindings
C.Show mpls Idp parameters
D.Show mpls Idp discovery
最新試題
What is the BGP synchronization rule?()
In optical transmission systems, chirped lasers are used for the purpose of:().
Which three things are the building blocks of the Cisco VPLS architecture?()
What are three common reasons for ATM CRC errors?()
Which two statements about DS-Lite are true?()
Which two routers support cable access?()
Which four statements about Ethernet virtual circuit (EVC) infrastructure are true? ()
Assume that the PEs are separated by Multiple P routers.How many labels should the ingress PE push for BPE functionality?()
Which option is not a valid method to assign the lowest-order 64-bit field of an IPv6 unicast address?()
Which information is carried in the OSPFv3 intra-area Prefix LSA?()