A. encryption—scrambles the packet contents to prevent them from being seen by unauthorized sources
B. password—a password (community string) sent in clear text between a manager and agent for added protection
C. authentication—determines that the message is from a valid source
D. message integrity—ensures that a packet has not been tampered with while it was in transit
E. user—to determine if user authentication is used instead of community strings
您可能感興趣的試卷
你可能感興趣的試題
A. Join interface is a Layer 3 entity, and with the Cisco NX-OS release 6.0, it can only be defined as a physical interface, physical subinterface, Layer 3 port channel, or Layer 3 port channel subinterface.
B. A single join interface can be defined and associated with a given OTV overlay.
C. Multiple overlays can also share the same join interface.
D. Join interface can be a loopback interface.
E. The join interface is a Layer 3 entity that can be defined as a physical interface but not as a logical one.
The network administrator is seeing N7K-1 having issues with VLAN 11, and interface VLAN 11 is resetting, causing frequent HSRP state changes. Which two actions would reduce HSRP state changes? ()
A..On N7K-1,configure the HSRP extended hold timer to 180, extending the HSRP hello message hold time.
B..On N7K-2,configure the HSRP extended hold timer to 180, extending the HSRP hello message hold time.
C..On N7K-1,configure the pre-empt delay minimum to 180 in order to delay N7K-1 from taking over as the HSRP active router.
D..On N7K-2,configure the pre-empt delay minimum to 180 in order to delay N7K-2 from taking over as the HSRP active router.
E..On N7K-2,increase the HSRP priority to 150.
F. On N7K-2,decrease the HSRP priority to 50.
A. When an OTV edge device receives a Layer 2 frame destined for a remote data center site, the frame is logically forwarded to the overlay interface.
B. The OTV edge device performs the dynamic OTV encapsulation on the Layer 2 packet and sends it to the join interface toward the routed domain.
C. When the OTV edge device receives a Layer 2 frame destined for a remote data center site, the frame is logically forwarded to the join interface.
D. The OTV edge device performs the dynamic OTV encapsulation on the Layer 2 packet and sends it to the overlay interface toward the routed domain.
A. port-profile
B. command
C. access-list
D. feature-group
E. OID
A. Enable feature vPC
B. Define domains
C. Establish peer keepalive connectivity
D. Create a peer link
E. Configure the peer link as a trunk port
F. Create port channels and vPCs
G. Define port channel load-balancing method
H. Make sure configurations are consistent
最新試題
What is the appliance port used to connect to in a Cisco Unified Computing System?()
What interface is created when an FC Port Channel is created on a Cisco Unified Computing System?()
Which three statements are possible causes for the "fltAdaptorHostIfLink-down" fault in UCS Manager? ()
Refer to the exhibit.The Cisco UCS domain is operating in switching mode. A network administrator notices that no traffic is traversing the uplinks on Fabric Interconnect B (Path C). Which actions might be used to change this behavior?()
What is the use of an "all configuration" backup in Cisco UCS?()
Given a Cisco Unified Computing System, which is a valid port type in end-host mode?()
In a Cisco Unified Computing System, What is the "designated receiver" port in end-host mode used for?()
Which statements are true regarding the Cisco UCS fabric failover feature? ()
Your company wants Server 1/eth0 (vNIC 1) configured so that it always uses Fabric Interconnect A Port Channel 1 (Po1) when it communicates with anything outside of the Cisco UCS domain. However, if vNIC 1 fails over to Fabric Interconnect B using fabric failover, then vNIC 1 can any uplink port on Fabric Interconnect B. Which statements are true? ()
Refer to the exhibit. According to the equipment tab in Cisco UCS Manager, which is true?()