多項選擇題Overlay Transport Virtualization (OTV) overlay interface is a logical multiaccess and multicast- capable interface that must be explicitly defined by the user and where the entire OTV configuration is applied. Which statements are true about OTV overlay interface?()

A. When an OTV edge device receives a Layer 2 frame destined for a remote data center site, the frame is logically forwarded to the overlay interface.
B. The OTV edge device performs the dynamic OTV encapsulation on the Layer 2 packet and sends it to the join interface toward the routed domain.
C. When the OTV edge device receives a Layer 2 frame destined for a remote data center site, the frame is logically forwarded to the join interface.
D. The OTV edge device performs the dynamic OTV encapsulation on the Layer 2 packet and sends it to the overlay interface toward the routed domain.


您可能感興趣的試卷

你可能感興趣的試題

2.多項選擇題A virtual port channel (vPC) allows links that are physically connected to two different Cisco Nexus devices to appear as a single port channel to a third device. Which are the mandatory steps for configuring vPC? ()   

A. Enable feature vPC
B. Define domains
C. Establish peer keepalive connectivity
D. Create a peer link
E. Configure the peer link as a trunk port
F. Create port channels and vPCs
G. Define port channel load-balancing method
H. Make sure configurations are consistent

4.多項選擇題The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer link. Which statements are true about the vPC peer-gateway? ()   

A. The vPC peer-gateway feature is enabled by default.
B. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
C. Enabling the peer-gateway feature automatically disables IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router.
D. The vPC peer-gateway feature only works with HSRP protocol.

6.多項選擇題You can install Cisco DCNM-LAN on a supported version of which two operating systems? ()

A. Microsoft Windows Server
B. Novell SUSE Linux Enterprise Server
C. Oracle Enterprise Linux
D. Red Hat Enterprise Linux
E. VMware ESX

7.多項選擇題DCNM device discovery is done by connecting to Cisco NX-OS devices and doing which three of these? () 

A. collecting the running configuration
B. raising the logging level to meet the minimum requirement
C. discovering all devices by default
D. discovering devices using multiple user accounts as long as they are administrator-level accounts
E. using LLDP to discover network adaptors

8.單項選擇題What is required for proper implementation of jumbo frame support on a Cisco Nexus 2000 Series Fabric Extender?()    

A. The interface configured as FEX fabric requires the MTU to be set to jumbo.
B. The service policy must be applied to the system QoS.
C. The device defaults to jumbo frame support; no changes are required.
D. The switchport in the FEX interface must be set to MTU 9216.

9.單項選擇題DCNM is capable of monitoring the network performance of a SAN. What are the three primary areas of this operation? ()  

A. analyze traffic, device management, and network monitoring
B. DCNM-SAN, DCNM-LAN, and device manager
C. definition of flows, information collection, and data presentation
D. SNMP poll data, MIB analysis, and report generation

10.多項選擇題Which two statements about authentication settings for DCNM-LAN are true? ()

A. If none of the authentication servers that are configured for the current authentication mode responds to an authentication request, the DCNM-LAN server falls back to localauthentication.
B. DCNM-LAN only supports TACACS+.
C. Each DCNM-LAN server will have the same device credentials.
D. Administering DCNM-LAN authentication settings requires an authentication license.
E. DCNM-LAN server users are local to the DCNM-LAN server.

最新試題

What is the appliance port used to connect to in a Cisco Unified Computing System?()

題型:單項選擇題

Where are SAN Port Channel is created in UCS Manager?()

題型:單項選擇題

Which GSS "source access list" is used to allow access to GSS by clients when GSS is being used as the DNS?()

題型:單項選擇題

What would be the cause for the following fault in UCS Manager?() "ether VIF x / xxx down, reason: ENM source pinning failed"

題型:單項選擇題

Which are valid statements about Cisco Virtual Interface Card (VIC)? ()

題型:多項選擇題

Which two statements about end-host mode in SAN connectivity in a Cisco UCS environment are true? ()

題型:多項選擇題

Your company wants Server 1/eth0 (vNIC 1) configured so that it always uses Fabric Interconnect A Port Channel 1 (Po1) when it communicates with anything outside of the Cisco UCS domain. However, if vNIC 1 fails over to Fabric Interconnect B using fabric failover, then vNIC 1 can any uplink port on Fabric Interconnect B. Which statements are true? ()

題型:多項選擇題

What is the use of an "all configuration" backup in Cisco UCS?()

題型:單項選擇題

An administrator creates a vNIC and assigns it to Fabric A with the fabric failover feature enabled. Which statement is true?()

題型:單項選擇題

Which of the following are supported in Cisco Global Site Selector? ()

題型:多項選擇題