Refer to the exhibit. Which two of these statements are correct? (Choose two.)（）
A. PE11 originated label 20.
B. PE11 originated label 21.
C. ThePE11 upstream neighbor originated label 21.
D. The PE11 downstream neighbor originated label 20.
E. PE11 will append label 21 to incoming packets labeled 32.
F. PE11 will impose label 20 on incoming packets labeled 32.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.
In the exhibit you can see the output of the show ip ospf neighbor detail command.
Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?（）
A. Stateful Switchover for Cisco Nonstop Forwarding only works with BGP.
B. Stateful Switchover for Cisco Nonstop Forwarding must be configured on all adjacent routers.
C. Cisco Nonstop Forwarding with Stateful Switchover helper mode is not supported on the adjacent router.
D. Cisco Nonstop Forwarding with Stateful Switchover helper mode for OSPF has been promiscuousstandardized and is supported on the adjacent router.
Refer to the exhibit. Which two of these events will be the result of issuing the above command? （）(Choose two.)
A. 64-bit IPv4 prefix will be created.
B. The route distinguisher will be used to indicate VPN membership.
C. Extended BGP communities will be used to encode route distinguishers.
D. A 96-bit VPNv4 prefix will be created and propagated across the IP network.
E. The route distinguisher is 64 bits and will be prepended to an existing IPv4 route to make it globally unique.
Refer to the exhibit. For the given configuration, on packets leaving the router on interface FastEthernet0/0 that matches the high traffic class, what will the MPLS experimental bit be set to?（）
A. 0
B. 1
C. 2
D. 3
E. 4
F. 5
A. disables OIR on the VAM2+ module
B. removes the VAM2+ crypto engine feature and disables the associated configuration commands from the router
C. disables dual VAM2+ hardware stateful failover capabilities
D. disables the crypto engine hardware acceleration, resulting in all crypto functions to be performed in software
A. To offload encryptions functions from router memory
B. To use WebVPN instead of IPSec
C. To decrease performance and efficiency
D. To offload encryption functions from a router CPU
最新試題
Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? （）(Choose two.)
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）
Refer to the exhibit. Which two of these events will be the result of issuing the above command? （）(Choose two.)
Refer to the exhibit. Which two of these statements are correct? (Choose two.)（）
What is the maximum number of Cisco Catalyst 3750 Series Switches that can be united into a single manageable unit using the Cisco StackWise technology?（）
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?（）
As an experienced technician, you are responsible for Technical Support in your company. One of the trainees is asking you which Cisco VPN Acceleration Module for Cisco 7200 Series routers and the Cisco 7301 provides high-performance encryption/compression and supports the latest encryption standard.Which of the following will answer his question?（）
Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?（）
In a RSTP implementation, which of the following two link types are used? （）(Choose two.)
Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?（）