A.data/coverage
B.location with Monitor Mode access points
C.demand
D.high density
您可能感興趣的試卷
你可能感興趣的試題
A.100 mW， 24 Mb/s
B.100 mW， 18 Mb/s
C.25 mW， 18 Mb/s
D.3.2 mW， 54 Mb/s
A.In a multifloor building， the access point layout from the survey of one floor can be directly applied to the remaining floors
B.Access points can be installed in the same place on every floor， without worrying about co-channelinterference
C.You can survey with a Cisco AIR-ANT5959 in a plenum environment
D.Identify all hazardous and restricted areas that might require extra or special survey and installationwork
A.Active mode does not require the client to be specifically confgured
B.Passive mode can survey more than one access point at a time
C.Active mode yields signal-quality information such as packet retries and lost packets
D.Active mode requires more time to survey but yields more information results than passive mode does
A.20 percent cell overlap
B.four access points detecting a client at -76 dBm or better
C.10 percent cell overlap
D.three access points detecting a client at -75 dBm or better
A.at 30mW
B.matched to the antenna gain
C.differing by at least 20 dBi
D.matched to each other
最新試題
When surveying for VoWLAN， which power level should you base the access point coverage designon？（）
What should be done if Cisco Spectrum Expert Wi-Fi reports a channel utilization of 40 percent onchannel 36， from a source outside of the site？（）
After the site installation is complete， you should verify the mobility of the VoWLAN device whilewalking the site on an active phone call. Which Cisco WLC or Cisco WCS command is mostbeneficial in determining roaming efficiency？（）
What does a Cisco Unified Wireless IP Phone 7921G deployment require（）？
Which statement about active and passive surveys is incorrect？（）
In an outdoor bridge link， what is calculated by using this formula： transmitter power + antennagain - insertion OR cable loss（）？
In which three frequency bands does the Cisco Spectrum Expert Wi-Fi tool perform spectrumanalysis？ （）
Which two Cisco antennas provide better isolation from RF sources that might be located behindthe antennas？（）
What will cause wireless voice devices to perform poorly？（）
The Cisco Aironet 1140 Series Access Point draws 12.95 W at the power source. However， whenusing a long Ethernet cable， the device can draw up to how much additional wattage？（）