A.40mW maximum transmit power
B.average power level of the VoWLAN clients
C.100mW transmit power
D.lowest power level of the VoWLAN clients
您可能感興趣的試卷
你可能感興趣的試題
A.Fresnel zone
B.SNR
C.SLR
D.PoE
E.EIRP
A.7
B.14
C.20
D.30
A.data/coverage
B.voice
C.location
D.mesh
E.public
F.WPAN
A.13 dBm
B.19 dBm
C.25 dBm
D.31 dBm
A.photographs
B.floor plans
C.wired network layout
D.blueprints
最新試題
Which format can NOT be imported into Cisco WCS Planning Tool?()
Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at thepredetermined data rate that is needed to support the VoWLAN device and call capacityrequirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920, 7921G, and7925G?()
How is attenuation measured?()
When planning for voice deployments with the Cisco Unified Wireless IP Phone 7921G handset in amultifloor building with a WLAN that operates at an 11 MB/s data rate, how many decibelsreferenced to 1 milliwatt of same-channel separation are recommended between floors?()
What does a Cisco Unified Wireless IP Phone 7921G deployment require()?
What is a site survey best practice for location-based services?()
Which three device types are identified by Cisco Spectrum Expert Wi-Fi finding an Avg PulseDuration parameter?()
What should be done if Cisco Spectrum Expert Wi-Fi reports a channel utilization of 40 percent onchannel 36, from a source outside of the site?()
According to the following statement, can you tell me which term is described?()It is the air return for an air conditioned system. In most buildings, the area above a drop ceiling orunder a raised floor is used as the air return (source of air) for the air conditioning. Those dropceiling and raised floors are also where wire is often installed. If wire and cable is installed in a dropceiling or raised floor, it is out of sight. If that cable were burning, it would give off toxic fumes.These would be fed to the rest of the building by the air conditioner. As a result, people could beinjured even though they are a long way from the fire.
Which two methods can be used to prevent or reduce RFI from colocated directional antennas()