An SVI has been configured on a device.
Which two statements are true about a switched virtual interface （SVI）？（）
A.An SVI is normally created for the default VLAN （VLAN1） to permit remote switch administration.
B.Multiple SVIs can be associated with a VLAN.
C.SVI is another name for a routed port.
D.An SVI is created by entering the no switchport command in interface configuration mode.
E.An SVI provides a default gateway for a VLAN.
您可能感興趣的試卷
你可能感興趣的試題
The following output was displayed on a switch.
Study the exhibit carefully. The administrator is verifying that a CEF FIB entry exists to destination network 192.168.150.0. Given the output generated by the "show ip cef" and "show adjacency detail" commands，
which three statements are true？ （）
A.The "valid cached adjacency" entry indicates that CEF will put all packets going to such an adjacency to the next best switching mode.
B.The number 003071506800 is the MAC address of the source IP address.
C.There is a valid CEF entry for the destination network 192.168.150.0.
D.The number 003071506800 is the MAC address of the 192.168.199.3 next hop IP address.
E.The counters （0 packets， 0 bytes） indicate a problem with the 192.168.199.3 next hop IP address.
F.There is an adjacency for the 192.168.199.3 next hop IP address.
You work as a network technician at. Your boss， Mrs. ， is interested in the Spanning Tree Protocol timers.
What can you tell her regarding the default STP timers？ （）
A.The hello time is 5 seconds.
B.The forward delay is 10 seconds.
C.The hello time is 2 seconds.
D.The forward delay is 15 seconds
E.The max_age timer is 15 seconds.
F.The hello time is 10 seconds.
G.The max_age timer is 20 seconds.
H.The forward delay is 20 seconds.
I.The max_age timer is 30 seconds.
A switch port on TK1 is being configured to support 802.1Q trunking.
Which of the following are true about 802.1Q trunking？（）
A.Both switches must be in the same VTP domain.
B.The encapsulation type of both ends of the trunk does not have to match.
C.The native VLAN on both ends of the trunk must be VLAN 1.
D.802.1Q trunking can only be configured on a Layer 2 port.
E.In 802.1Q trunking， all VLAN packets are tagged on the trunk link， except the native VLAN.
A.forwarding information base
B.adjacency tables
C.neighbor tables
D.caching tables
E.route tables
A.Address Resolution Protocol （ARP）
B.PDU header rewrite
C.NetFlow switching
D.hello packet exchange
最新試題
Refer to the exhibit. What does the command channel-group 1 mode desirable do？ （）
Refer to the exhibit. Based on the output of the show spanning-tree command， which statement is true？ （）
How are STP timers and state transitions affected when a topology change occurs in an STP environment？（）
Refer to the exhibit. What will happen when one more user is connected to interface FastEthernet 5/1？ （）
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result？（）
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals？（）
Refer to the exhibit. STP has been implemented in the network. Switch SW_A is the root switch for the default VLAN. To reduce the broadcast domain， the network administrator decides to split users on the network into VLAN 2 and VLAN 10. The administrator issues the command spanning-tree vlan 2 root primary on switch SW_A. What will happen as a result of this change？（）
Refer to the exhibit. On the basis of the output of the show spanning-tree inconsistentports command， which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true？（）
Refer to the exhibit. Initially， LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements are true about the possible result of attaching the second link？（）
Which statement is correct about RSTP port roles？（）