You need to configure a new Company Catalyst 3560 switch for a VOIP-enabled office.
Which three statements are true about the voice VLAN feature on this switch？（）
A.The default CoS value for incoming traffic is set up to 0.
B.The CoS value is trusted for 802.1p or 802.1q tagged traffic.
C.PortFast is automatically disabled when a voice VLAN is configured.
D.The voice VLAN feature is disabled by default.
E.The IP phone accepts the priority of all tagged and untagged traffic and sets the CoS value to 4.
F.When the voice VLAN feature is enabled， all untagged traffic is sent according to the default CoS priority of the port
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Which statement is true about a voice VLAN？（）
A.Physically the voice network and the data network are separate.
B.The voice traffic will normally be on a different IP subnet than will the data traffic.
C.End user intervention is necessary to place the phone into the proper VLAN.
D.The same security policy should be implemented for both voice and data traffic.
E.The data VLAN must be configured as the native VLAN.
A.TCP retransmits
B.UDP priority
C.Bursty
D.Delay sensitive
E.Greedy
F.Drop sensitive
Refer to the exhibit.
What are three of the basic components of a VoIP network？（）
A.software voice applications
B.multipoint control unit （MCU）
C.gatekeeper
D.call agent
E.interactive voice response （IVR） systems
F.softphones
A.The use of a queuing method that will give VoIP traffic strict priority over other traffic
B.The use of RTP header compression for the VoIP traffic.
C.The proper classification and marking of the traffic as close to the source as possible
D.The use of 802.1QinQ trunking for VoIP traffic
E.The use of WRED for the VoIP traffic
You need to troubleshoot some problems in the Company VOIP network associated with jitter.
What is the cause of jitter？ （）
A. Packet drops
B. Transmitting too many small packets
C. Variable queue delays
D. Compression
E. None of the other alternatives apply
最新試題
Refer to the exhibit. On the basis of the output of the show spanning-tree inconsistentports command， which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true？（）
DS2 has not become the active device for Vlan103’s HSRP group even though all interfaces are active. As related to Vlan103’s HSRP group. What can be done to make the group function properly ？ （）
Refer to the exhibit. All network links are FastEthernet. Although there is complete connectivity throughout the network， Front Line users have been complaining that they experience slower network performance when accessing the server farm than the Reception office experiences. Based on the exhibit， which two statements are true？（）
Refer to the exhibit. Switch S2 contains the default configuration. Switches S1 and S3 both have had the command spanning-tree mode rapid-pvst issued on them. What will be the result？（）
During routine maintenance， G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However， after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ？ （）
If G1/0/1 on DS1 is shutdown， what will be the current priority value of the Vlan105’s group on DS1 ？（）
Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge.Which switch should theadministrator configure as the root bridge and which configuration command must theadministrator enter to accomplish this？（）
Based on the show spanning-tree vlan 200 output shown in the exhibit， which two statements about the STP process for VLAN 200 are true？ （）
Which statement is correct about the use of the virtual interface on a WLC ？（）
Which option correctly identifies the Cisco IOS switching methods in descending order from the fastest method to the slowest method？（）