A.Only OSPF version 3 can be utilized for routing IPv4 and IPv6
B.IPv4 and IPv6 networks can be routed simultaneously
C.IPv6 can be routed using the same routing protocol versions as IPv4
D.A router routing for IPv6 and IPv4 must convert IPv4 packets to IPv6 packets to route them
E.None of the other alternatives apply
您可能感興趣的試卷
你可能感興趣的試題
A.192.168.30.1：0：0：0：0：0：0
B.0：0：0：0：0：0：192.168.30.1
C.：：192.168.30.1
D.C0A8：1E01：：
E.192.168.30.1：：
F.：：C0A8：1E01
A.The route table is cleared. Then the OSPF neighbors are reformed
B.The OSPF adjacencies are cleared and initiated again
C.The OSPF database is repopulated and then the shortest path first （SPF） algorithm isperformed.
D.The shortest path first （SPF） algorithm is performed on the LSA database
E.None of the other alternatives apply
Refer to the exhibit. What two statements are true？（）
A.The IP address of the backup designated router （BDR） is FE80：：205：5FFF：FED3：5808
B.This is the designated router （DR） on the FastEthernet 0/0 link
C.Interface FastEthernet 0/0 was configured with the ipv6 ospf 1 area 1 command
D.OSPF version 2 has been enabled to support IPv6
E.The output was generated by the show ip interface command
Refer to the output. What IOS command produces this output？（）
A.show ip ospf
B.show ip ospf interface
C.show ipv6 ospf interface
D.show ipv6 ospf
Refer to the exhibit. Assume that Switch_A is active for the standby group and the standby devicehas only the default HSRP configuration. What conclusion is valid？（）
A.If port Fa1/1 on Switch_A goes down， the standby device will take over as active
B.If the current standby device were to have the higher priority value， it would take over the role ofactive for the HSRP group
C.If Switch_A had the highest prioritynumber， it would not take over as active router
D.If port Fa1/1 on Switch_A goes down， the new priority value for the switch would be 190
最新試題
Drag the IPsec protocol description from the above to the correct protocol type on the below.（Notall descriptions will be used）Drag and Drop question， drag each item to its proper location.
Drag and drop each management protocol on the above to the correct category on the below.
Drag the DSL technologies on the left to their maximum（down/up） data rate values on the below.
As a network engineer， do you know for what purpose SDM uses Security Device Event Exchange（SDEE）？（）
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password？（）
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.
Which statement about PPPoA configuration is correct？（）
cisco ios command to interface dialer 0
Study the exhibit carefully.Routers A and B are customer routers. Routers 1， 2， 3 and 4 are provider routers. The routers areoperating with various IOS versions. Which frame mode MPLS configuration statement is true？（）
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）