Refer to the exhibit. VTP has been enabled on the trunk links between all switches within the TEST domain. An administrator has recently enabled VTP pruning. Port 1 on Switch 1 and port 2 on Switch 4 are assigned to VLAN 2. A broadcast is sent from the host connected to Switch 1. Where will the broadcast propagate?（）
A.Every switch in the network receives the broadcast and will forward it out all ports.
B.Every switch in the network receives the broadcast，but only Switch 4 will forward it out port 2.
C.Switches 1，2，and 4 will receive the broadcast，but only Switch 4 will forward it out port 2.
D.Only Switch 4 will receive the broadcast and will forward it out port 2.
您可能感興趣的試卷
你可能感興趣的試題
A.30 seconds
B.5 minutes
C.1 minute
D.10 seconds
E.5 seconds
F.None of the other alternatives apply
A.A root VTP server
B.A trunk port
C.VTP priority
D.VLAN 1
E.None of the other alternatives apply
A.STP root status
B.VTP mode
C.Negotiation status
D.Management domain
E.Configuration revision number
A.Devices use DHCP to request their VLAN.
B.Attached devices are unaware of any VLANs.
C.Devices are assigned to VLANs based on their MAC addresses.
D.Devices are in the same VLAN regardless of which port they attach to.
A.VMPS server lookup is required
B.Easy to configure
C.Easy of adds，moves，and changes
D.Based on MAC address of the connected device
最新試題
Which statement is correct about RSTP port roles？（）
What must be the same to make multiple switches part of the same Multiple Spanning Tree （MST）？（）
Refer to the exhibit. Which statement is true about the output？（）
Which option correctly identifies the Cisco IOS switching methods in descending order from the fastest method to the slowest method？（）
What two things will occur when an edge port receives a BPDU？（）
Which router redundancy protocol cannot be configured for interface tracking？（）
Which statement is correct about the use of the virtual interface on a WLC ？（）
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result？（）
During routine maintenance， it became necessary to shutdown G1/0/1 on DS1 and DS2. All other interface were up. During this time， DS1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. What can be done to make the group function properly ？ （）
Refer to the exhibit. Switch 15 is configured as the root switch for VLAN 10 but not for VLAN 20. If the STP configuration is correct， what will be true about Switch 15？（）