Refer to the exhibit.The network administrator normally establishes a telnet session with the switch from host A.However,host A is unavailable.The administrator′s attempt to the switch from host B fails,but pings to the other two hosts are successful.what is the issue?（）
A.Host B and the switch need to be in the same subnet.
B.The switch needs and appropriate default gateway assigned.
C.The switch interface connected to the router is down.
D.Host B need to be assigned an IP address in vlan 1.
E.The switch interfaces need the appropriate IP addresses assigned.
您可能感興趣的試卷
你可能感興趣的試題
A.it is a layer 2 messaging protocol which maintains vlan configurations across network.
B.it includes an 8-bit field which specifies the priority of a frame.
C.it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D.it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E.it is a trunking protocol capable of carring untagged frames.
Based on the network shown in the graphic which option contains the potential networking problem and protocol or setting that can to prevent the problem?（）
A.Routing loops, hold down timers
B.Switching loops, split horizon
C.Routing loops, split horizon
D.Switching loops, VTP
E.Routing loops, STP
F.Switching loops, STP
A.ping address
B.tracert address
C.traceroute address
D.arp address
A.added security
B.dedicated bandwidth
C.provides segmentation
D.allows switches to route traffic between subinterfaces
E.contains collisions
Refer to the exhibit. Which statement is true?（）
A.The Fa0/11 role confirms that SwitchA is the root bridge for VLAN 20.
B.VLAN 20 is running the Per VLAN Spanning Tree Protocol.
C.The MAC address of the root bridge is 0017.596d.1580.
D.SwitchA is not the root bridge, because not all of the interface roles are designated.
A.source MAC address
B.source IP address
C.source switch port
D.destination IP address
E.destination port address
F.destination MAC address
A.data link
B.network
C.physical
D.transport
A.RSTP significantly reduces topology reconverging time after a link failure.
B.RSTP expends the STP port roles by adding the alternate and backup roles.
C.RSTP port satates are blocking,discarding,learing,or forwarding.
D.RSTP also uses the STP proprsal-agreement sequence.
E.RSTP use the same timer-baseed process as STP on point-to-point links.
F.RSTP provides a faster transition to the forwarding state on point-to-point links than STP does.
Refer to the exhibit A frame on vlan 1 on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?（）
A.trunk mode mismatches
B.vlans that do not correspond to a unique IP subnet
C.native vlan mismatches
D.allowing only vlan 2 on the destination.
Refer to the topology shown in the exhibit. Which ports will be STP designated ports if all the links are operating at the same bandwidth? （）
A.Switch A - Fa0/0
B.Switch A - Fa0/1
C.Switch B - Fa0/0
D.Switch B - Fa0/1
E.Switch C - Fa0/0
F.Switch C - Fa0/1
最新試題
What are the three things that the Netflow uses to consider the traffic to be in a same flow ?（）
What command instructs the device to timestamp Syslog debug messages in milliseconds?（）
What command visualizes the general NetFlow data on the command line?（）
Refer to the exhibit.If the router Cisco returns the given output and has not had its router ID set manually, what value will OSPF use as its router ID?（）
Which three features are added in SNMPv3 over SNMPv2 ? （）
What are three values that must be the same within a sequence of packets for Netflow to consider them a network flow?（）
What parameter can be different on ports within an EtherChannel?（）
In GLBP, which router will respond to client ARP requests?（）
What are two benefits of using a single OSPF area network design?（）
In a GLBP network, who is responsible for the arp request?（）