單項選擇題Which command can be used from a PC to verify the connectivity between hosts that connect through a switch in the same LAN?()

A.ping address
B.tracert address
C.traceroute address
D.arp address


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題Which two benefits are provided by creating VLANs? ()

A.added security
B.dedicated bandwidth
C.provides segmentation
D.allows switches to route traffic between subinterfaces
E.contains collisions

2.單項選擇題

Refer to the exhibit. Which statement is true?()

A.The Fa0/11 role confirms that SwitchA is the root bridge for VLAN 20.
B.VLAN 20 is running the Per VLAN Spanning Tree Protocol.
C.The MAC address of the root bridge is 0017.596d.1580.
D.SwitchA is not the root bridge, because not all of the interface roles are designated.

3.單項選擇題What dose a Layer 2 switch use to decide where to forward a received frame?()

A.source MAC address
B.source IP address
C.source switch port
D.destination IP address
E.destination port address
F.destination MAC address

4.單項選擇題At which layer of the OSI model is RSTP used to prevent loops?()

A.data link
B.network
C.physical
D.transport

5.多項選擇題Which three statements about RSTP are true?()

A.RSTP significantly reduces topology reconverging time after a link failure.
B.RSTP expends the STP port roles by adding the alternate and backup roles.
C.RSTP port satates are blocking,discarding,learing,or forwarding.
D.RSTP also uses the STP proprsal-agreement sequence.
E.RSTP use the same timer-baseed process as STP on point-to-point links.
F.RSTP provides a faster transition to the forwarding state on point-to-point links than STP does.

6.單項選擇題

Refer to the exhibit A frame on vlan 1 on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?()

A.trunk mode mismatches
B.vlans that do not correspond to a unique IP subnet
C.native vlan mismatches
D.allowing only vlan 2 on the destination.

7.多項選擇題

Refer to the topology shown in the exhibit. Which ports will be STP designated ports if all the links are operating at the same bandwidth? ()

A.Switch A - Fa0/0
B.Switch A - Fa0/1
C.Switch B - Fa0/0
D.Switch B - Fa0/1
E.Switch C - Fa0/0
F.Switch C - Fa0/1

8.單項選擇題Which statement about vlan operation on cisco catalyst switches is true?()

A.when a packet is received from an 802.1Q trunk,the vlan id can be determined from the source MAC address table.
B.unkown unicast frames are retransmitted only to the ports that belong to the same vlan
C.ports between switches should be configured in access mode so that vlans can span across the ports
D.broadcast and multicast frames are retransmitted to ports that are configured on different vlan.

9.單項選擇題assuming the default switch configuration which vlan range can be added modified and removed on a cisco switch?()

A.2 through 1001
B.1 through 1001
C.1 through 1002
D.2 through 1005

10.多項選擇題Which two link protocols are used to carry multiple VLANs over a single link? ()

A.VTP
B.802.1q
C.IGP
D.ISL
E.802.3u