A. to configure a subinterface so that it can be applied to the primary interface in order to prevent exponential selective dampening
B. to suppress the effects of excessive interface flapping events on routing protocols and routing tables in the network
C. to introduce a nonconfigurable exponential delay mechanism
D. to allow the network operator to configure a router to automatically dampen and selectively identify a local interface that is failing
您可能感興趣的試卷
你可能感興趣的試題
CIS .com recently acquired a smaller competitor. The acquired company is not currently using Cisco routers, so you have connected the two WANs via an authenticated PPP link. After configuration both routers, issuing the show interface s0/0 command on the Cisco Router shows the interface to be in the up/down state.
Which two of these are possible causes? （）
A. Bandwidth statements do not match
B. MTUs do not match
C. IP Addresses are not in the same subnet
D. CHAP passwords do not match
A. flags indicating the kind of autoconfiguration that can be done by hosts
B. default router information
C. /64 prefix that can be used on the link and the lifetime of the prefix
D. IPv6 DHCP server address information
A. isolated mode
B. modular mode
C. community mode
D. promiscuous mode
E. non-isolated
F. permanent
A.65536
B.256
C.1024
D.16777216
最新試題
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:（）
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?（）
What is the function of the no switchport catalyst switch interface configuration command?（）
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?（）
In a RSTP implementation, which of the following two link types are used? （）(Choose two.)
When a Cisco router is configured for SSH, it acts as an （）?
Refer to the exhibit. You have a non-Cisco switch that is not communicating properly while connected to the distribution-layer Cisco switching fabric.Which two best-practice actions can you take to overcome this problem? （）(Choose two.)
Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? （）(Choose two.)
Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?（）
Which three of these items are IPv6 transition mechanisms? （）(Choose three.)