Study the exhibit shown below carefully.
In this scenario the service provider wants to ensure that switch S1 is the root switch for its own network and the network of .
On which interfaces should root guard be configured to ensure that this happens？（）
A.Interfaces 11 and 12
B.Interfaces 1， 2， 3， and 4
C.Interfaces 5 and 6
D.Interfaces 5， 6， 7， and 8
E.Interfaces 1 and 2
F.Interfaces 1， 3， 5， and 6
您可能感興趣的試卷
你可能感興趣的試題
In order to enhance worker productivity， a Cisco wireless network has been implemented at all locations.
Which three statements regarding WLAN are true？（）
A.A WLAN client will operate in half-duplex mode.
B.The Aironet 1230 access point is an example of an access point that operates solely as a lightweight access point.
C.Ad hoc mode allows mobile clients to connect directly without an intermediate AP.
D.WLANs are designed to share the medium and can easily handle an increased demand of channel contention.
E.A lightweight AP receives control and configuration from a WLAN controller to which it is associated.
F.Another term for infrastructure mode is independent service set （IBSS）.
Switch 1 was configured as shown below：
Based on the output shown above，
which statement is true？ （）
A.IP traffic matching access list is forwarded through VLANs 5-10.
B.All VLAN traffic in VLANs 5-10 that match access list will be forwarded， and all else will be dropped.
C.IP traffic matching VLAN list 5-10 will be forwarded， and all other traffic will be dropped.
D.All VLAN traffic matching VLAN list 5-10 will be forwarded， and all traffic matching access list is dropped.
E.None of the other alternatives apply
A. QoS
B. call setup and teardown
C. call routing
D. call supervision
E. audio signal compression
A. device PoE requirements
B. device IP address
C. device voice VLAN ID
D. device platform
A. an edge port that transitions to the forwarding state
B. a non-edge port that transitions to the blocking state
C. a non-edge port that transitions to the forwarding state
D. an edge port that transitions to the blocking state
E. any port that transitions to the blocking state
F. any port that transitions to the forwarding state
最新試題
Which three statements about STP timers are true？（）
Refer to the exhibit. Which Virtual Router Redundancy Protocol （VRRP） statement is true about the roles of the master virtual router and the backup virtual router？（）
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals？（）
Refer to the exhibit. What will happen when one more user is connected to interface FastEthernet 5/1？ （）
Refer to the exhibit. Initially， LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements are true about the possible result of attaching the second link？（）
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2？（）
Which router redundancy protocol cannot be configured for interface tracking？（）
Refer to the exhibit. Switch S2 contains the default configuration. Switches S1 and S3 both have had the command spanning-tree mode rapid-pvst issued on them. What will be the result？（）
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2？（）
Which two statements are true when the extended system ID feature is enabled？ （）