A. path cost
B. lowest port MAC address
C. VTP revision number
D. highest port priority number
E. port priority number and MAC address
您可能感興趣的試卷
你可能感興趣的試題
A. It is used with the OSPF priority values to determine which OSPF router will become the DR or BOR in a point-to-point network
B. It is used with the OSPF priority values to determine which interface will be used to form a neighbor relationship with another OSPF router
C. It is used with the OSPF priority values to determine which router will become the DR or BOR in a multi access network
D. It is used to determine which interfaces will send Hello packets to neighboring OSPF routers
A. Show vlan
B. Show mac-address-table
C. Show vtp status
D. show spanning-tree root
E. show ip interface brief
A. A configured router prompts for a password
B. A configured router goes to the privileged mode prompt
C. An un configured router goes into the setup dialog
D. An un configured router goes to the enable mode prompt
A. when all switches have the same BID as the root switch
B. when all switches have received the MAC address of each neighboring switch
C. when every enabled switch port has been assigned a unique identifier
D. when every operating switch port is in either the blocking or forwarding state
E. when all switches are in either client, server, or transparent mode
A. a serial cable with a V.35 to RJ45 adapter
B. a CSU/DSU
C. an external ISDN TA and NT1
D. The non-modular router cannot connect to an ISDN service. The network administrator must purchase a modular router with an ISDN BRI-U card.
最新試題
Which of the following contribute to congestion on an Ethernet network?（）
Which characteristics are representative of a link-state routing protocol?（）
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?（）
What feature of a networks switch allows an administrative to create separate broadcast domains?（）
Which statement describes the rule of split horizon?（）
New switches have been purchased for a network upgrade. The objective for the network design emphasizes efficient, error-free transport instead of fast transport.Which switching mode should be configured on the new switches to provide error-free transport to the network? （）
The following access list was applied outbound on he E0 interface connected to the 192.168.1.8/29 LAN:access-list 123 deny tcp 192.168.1.8 0.0.0.7 eq 20 anyaccess-list 123 deny tcp 192.168.1.9 0.0.0.7 eq 21 anyWhat effect will this access list have?（）
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? （）
You are configuring a new Catalyst switch that you want to manage remotely from workstations on other network segments within your enterprise.Which of the following are required to allow remote management of the switch over IP?（）
What does a configuration Register Setting of 0x2105 indicate to the Router? （）