A. The source device will only retransmit lost packets on the request of the destination device.
B. The source device starts a timer when it sends a segment and retransmits if an acknowledgment is not received before the timer expires.
C. The destination device acknowledges receipt of a segment by sending a packet with a new sequence number and the ACK bit sent.
D. The destination device acknowledges receipt of a segment by sending a packet that indicates the next sequence number it expects.
E. If the destination device does not receive a segment, all segments are retransmitted.
F. The source device keeps a record of all segments sent and expects and acknowledgment of each.
您可能感興趣的試卷
你可能感興趣的試題
A.MTU
B.PDU
C.FCS
D.Flag
E.MAC
F.BRI
A. ERR
B. Flag
C. FCS
D. MTU
E. MAC
F. PDU
A. source and destination MAC address
B. source MAC address and destination network address only
C. source and destination network address only
D. source network address and destination MAC address
E. source and destination MAC address and source and destination network address
A.NT2
B.NT1
C.TE
D.TA
E.TE1
A. Packet Switching
B. Access Layer Security
C. Path Selection.
D. VLAN Membership Assignment.
E. Bridging between LAN segments.
F. Micro-segmentation of Broadcast Domains.
最新試題
What is a global command?（）
Which characteristics are representative of a link-state routing protocol?（）
A Class C network address has been subnetted with a /27 mask.Which of the following addresses is a broadcast address for one of the resulting subnets?（）
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? （）
Which statement describes the rule of split horizon?（）
A network host is configured as follows: Host IP address: 192.168.16.183 Subnet mask: 255.255.255.224 Default gateway: 192.168.16.190 Which of the following statements describe the network to which this host is attached?（）
The following access list was applied outbound on he E0 interface connected to the 192.168.1.8/29 LAN:access-list 123 deny tcp 192.168.1.8 0.0.0.7 eq 20 anyaccess-list 123 deny tcp 192.168.1.9 0.0.0.7 eq 21 anyWhat effect will this access list have?（）
Which connections allow the use of full-duplex Ethernet?（）
The network 172.12.0.0 needs to be divided into subnets where each subnet has the capacity of 458 IP addresses.What would be the correct subnet mask to accomplish this division keeping the number of subnets at the maximum? （）
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational? （）