多項選擇題Which three of the statements below correctly describe the characteristics of Autonomous Systems in routed networks?()

A. Within an AS, all routers must run either BGP or IBGP.
B. An AS uses exterior gatew ay protocols (EGPs) to exchange information with other autonomous systems.
C. An AS is a group of routers under the same technical administration.
D. Within an AS, routes learned through BGP can be redistributed using interior gateway protocols.
E. Wi thin an AS, routes learned through an interior protocol cannot be redistributed using BGP to other autonomous systems.


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題Which three conditions can cause BGP n eighbor establishment to fail?()

A. The IBGP neighbor is not directly connected.
B. BGP synchronization is enabled in a transit autonomous system with fully - meshed IBGP neighbors.
C. The EBGP neighbor ebgp - multihop option is set to the de fault value.
D. The BGP update interval is different between the two BGP neighbors.
E. The BGP neighbor is referencing an incorrect autonomous system number in its neighbor statement.
F. There is an access list blocking all TCP traffic between the two  BGP neighbors.

2.單項選擇題Which command displays the IBGP and EBGP neighbors that are configured?()

A. show ip bgp paths
B. show ip bgp peers
C. show ip bgp
D. show ip bgp summary

3.單項選擇題When the BGP path selection process is being performed on a Cisco router, which BGP attribute is used first when determining the best path?()

A. local preference
B. MED
C. weight
D. or igin
E. next - hop
F. AS - path

4.多項選擇題Which two methods advertise internal networks to external ISPs via BGP?()

A. using aggregate routes
B. defining routes via the network statement
C. disablin g synchronization
D. forcing the next - hop address

5.單項選擇題

Refer to the exhibit The neighbor 10.1.1.1 weight 200 BGP configuration command has been configured on router A. What will be the result of this configuration? ()

A. Router A will prefer the path through router B for network 172.20.0.0
B. Router A will prefer the path through router C for network 172.20.0.0
C. Packets from router D will prefer the path through router B for networks advertised by router A
D. Packets from r outer D will prefer the path through router C for networks advertised by router A

最新試題

Router R1 has two LAN interfaces and three serial interfaces enabled for IPv6. All the inte rfaces use link local addresses automatically generated by the router.Which of the following could be the link local address of R1's interface S0/0?()

題型:單項選擇題

An engineer is trying to summarize the following networks using the "ip summary- address eigrp"command:10.8.88.0/2510.8.89.48/2910.8.64.96/27Which network and subnet mask below would be the smallest EIGRP summary address to include all three subnets?()

題型:單項選擇題

Which of the following is helpful to allow an IPv6 host to learn the IP address of a default gateway on its subnet?()

題型:單項選擇題

Router R1 use s MAC address 1111.1111.1111 for its Fa0/0 interface. An engineer sees the following configuration in the output of a show running - config command. Then, the engineer issues a show ipv6 interface brief command. What global unicast IPv6 address does this c ommand display for interface tunnel 1?()interface loopback 1ip address 192.168.1.1 255.255.255.255interface tunnel 1tunnel source loopback 1tunnel destination 192.168.1.2tunnel mode ipv6ip isatapipv6 address 2000::/64 eui - 64

題型:單項選擇題

Router R1 lists the following output from a show command. Which of the following is true about R1?()R1# show ip v6 interface f0/0FastEthernet0/0 is up, line protocol is upIPv6 is enabled, link - local address is FE80::213:19FF:FE12:3456No Virtual link - local address(es):Global unicast address(es):2000::4:213:19FF:FE12:3456, subnet is 2000:0:0:4::/64 [EUI]Jo ined group address(es):FF02::1FF02::2FF02::1:FF:12:3456

題型:單項選擇題

An engineer is reviewing another engineer's sample configuration for a GRE tunnel used to pass IPv6 traffiC. The tunnel ha s not yet been configured on the router.Which of the following commands is not required for the configuration to pass IPv6 traffic?()

題型:單項選擇題

An Enterprise rou ter, Ent1, displays the following excerpt from the show ip bgp command. ENT1 has an eBGP connection to an ISP router with address 3.3.3.3 and an iBGP connection to a router with address 4.4.4.4. Which of the following is most likely to be true?()Network  Next Hop Metric LocPrf Weight Path*> 3.3.3.3 0 0 1 1 1 1 218 i

題型:單項選擇題

Router R1 has the following configuration. Assuming R1's F0/0 interface has a MAC address of 0200.0011.1111, what IPv6 addresses will R1 list for interface F0/0 in the output of the show ipv6 interface brief command?()interface f0/0ipv6 address 2345:0:0:8::1/64

題型:多項選擇題

The answers each list a tunnel method and two consecutive IPv6 address quartets.Which answers identify a tunneling method that relies on an IPv4 address to be embedded into an IPv6 address, within the correct quartets listed?()

題型:多項選擇題

Which of the following are true of both OSPFv2 and OSPFv3?()

題型:多項選擇題