A. Router# copy tftp flash
B. Router# copy flash run
C. Router(config)# restore flash
D. Router(config)# repair flash
E. Router#copy flash tftp
F. Router# copy start flash
您可能感興趣的試卷
你可能感興趣的試題
After making changes to the router, you issue the "copy running-config startup-config" command to save changes. After reloading the router, the router comes up in setup mode. You again make changes, save them, and reboot. Again,the router comes up in setup mode.
What is the most likely cause of this?（）
A. The NVRAM is corrupted.
B. The boot system commands were omitted in the configuration.
C. The configuration register setting is incorrect.
D. The upgraded configuration incompatible with the hardware platform.
E. The upgraded IOS incompatible with the hardware.
A. Router# show IOS
B. Router# show version
C. Router# show image
D. Router# show protocols
E. Router# show flash
A. It is used to restart the router.
B. It is used to bypass the configuration in NVRAM.
C. It is used to enter ROM Monitor mode.
D. It is used to view the lost password.
E. It is used to save the changes to the configuration.
A. Type exit at the setup dialog.
B. Type close at the setup dialog.
C. Press the Ctrl-C key combination.
D. Press the Ctrl-X key combination.
E. Issue the copy startup-config command.
F. Issue the 'write e" command.
G. Issue the "write mem" command
After working all night and successfully configuring a Cisco router for the TestKing network you save your changes on the startup config, reboot the router, and go out for a cigarette. When you return, none of your changes are active and the router boots to the initial configuration mode!
Which of the choices below indicates the source of your problem?（）
A. Hardware failure in NVRAM prevents the router from loading the config
B. Startup-config in flash is corrupt and cannot be analyzed
C. Router configuration-register set to bypass startup configuration
D. Startup-config in NVRAM is corrupt and cannot be analyzed
E. None of the above
最新試題
Which of the following statements regarding routed and routing protocols are true?（）
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?（）
Which command is used to display the placement and direction of an IP access control list on a router?（）
The following access list was applied outbound on he E0 interface connected to the 192.168.1.8/29 LAN:access-list 123 deny tcp 192.168.1.8 0.0.0.7 eq 20 anyaccess-list 123 deny tcp 192.168.1.9 0.0.0.7 eq 21 anyWhat effect will this access list have?（）
TestKing.com has allocated the IP add 199.144.27.0 is its network, to provide flexibility for the LAN design, a subnet mask of 255.255.255.240 has been chosen. Which of the following address can be assigned to LAN on the resulting subnets.（）
Which of the following if addresses can be assigned to host devices?（）
A Class C network address has been subnetted with a /27 mask.Which of the following addresses is a broadcast address for one of the resulting subnets?（）
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? （）
Given a subnet mask of 255.255.255.224, which of the following addresses can be assigned to network hosts?（）
Which statement describes the rule of split horizon?（）