A.Quality of Service
B.Trunk configuration
C.Access lists
D.Routing protocol configuration
E.Power over Ethernet
F.DHCP configuration
您可能感興趣的試卷
你可能感興趣的試題
A.Create an IPv4 tunnel and assign the tunnel IPv6 addresses
B.Create IPv4 interfaces on both ends of the network， and use either static routes or a routingprocess to direct IPv6 packets through those interfaces
C.IPv6 packets cannot be encapsulated with IPv4 headers because the addresses are notcompatible
D.Create IFV6 interfaces on both ends of the network， and use static routes to point the IPv4address to those interfaces
E.Use an IPv6 routing protocol like OSPFv3 and assign IPv4 packets to that process
F.Create an IPv4 tunnel and use the tunnel mode ipv6ip command
A.show ip route ∣ to tftp：//192.168.1.1/route.txt
B.show ip route ∣ tee tftp：//192.168.1.1/route.txt
C.show ip route ∣ include tftp：//192.168.1.1/route.txt
D.show ip route ft include tJtp：//19Z168.1.1/route.txt
E.show ip route ∣ redirect tftp：//192.168.1.1/route.txt
A.Link-local address used for next-hop addresses
B.Interface can be added to RIP routing process in either interface configuration mode or in routerconfiguration mode
C.Uses a multicast to send routing updates
D.Use hop count as a metric
E.Distance-vector routing protocol
F.Maximum hop count is 15 with 16 being "unreachable"
A.The default-metric command configured under the appropriate interface
B.The metric parameter in the network command of a routing process
C.The metric parameter in the redistribute command
D.The default-metric command
E.A route-map containing a seed command
F.A route map containing a metric command
A.Designated port
B.Nonswitch port
C.Switch port
D.Nonroot port
E.Nondesignated port
F.Root port
最新試題
Drag and drop the xDSL type on the above to the appropriate xDSL description on the below.
Drag the IOS commands from the left that would be used to implement a GRE tunnel using the10.1.1.0.30 network on interface serial 0/0 to the correct target area on the right.
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clickingthe numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible. To gain access to either thetopology or the SDK click on the button to left side of the screen that corresponds to the sectionyou wish to access. When you have finished viewing the topology the SDK you can return to yourquestions by clicking on the Questions button to the left.Which IPSec rule is used for the Olympia branch and what does it define？（）
Which statement about PPPoA configuration is correct？（）
Drag the DSL technologies on the left to their maximum（down/up） data rate values on the below.
Drag the DSL local loop topic on the left to the correct descriptions on the right.
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
Drag the correct statements about MPLS-based VPN on the left to the boxes on the right.（Not allstatements will be used）
As a network engineer， do you know for what purpose SDM uses Security Device Event Exchange（SDEE）？（）
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）