A.MAC spoofing
B.VLAN hopping
C.MAC address flooding
D.DHCP flooding
E.Session hijacking
您可能感興趣的試卷
你可能感興趣的試題
A.Enable BPD guard
B.Disable CDP on ports where it is not necessary
C.Place unused ports in a common unrouted VLAN
D.Prevent automatic trunk configuration
E.Implement port security
Refer to the exhibit. Based upon the configuration， you need to understand why the policy routingmatch counts are not increasing. Which would be the first logical step to take？Select the bestresponse.（）
A.Confirm if there are other problematic route-map statements thatprecede divert
B.Check the access list for log hits
C.Check the routing table for 212.50.185.126
D.Remove any two of the set clauses（Multiple set clause entries will cause PBR to use therouting table.）
Study the following graphic carefully Host1 and Host2， which belong to different VLANs， are in thesame subnet. According to the information displayed， which description is correct when trying toping from host to host？（）
A.A trunk port should be configured on the link between CK-SW1 and CK-SW2 to pingsuccessfully
B.The two hosts should be in the same VLAN in order to ping successfully
C.A Layer 3 device is a must in order for the ping command to be successful
D.The ping command will be successful without any further configuration changes
Refer to the exhibit. VLAN2， VLAN3， and VLAN10 are configured on the switch D-SW1.Host computers are on VLAN 2 （10.1.2.0）， servers are on VLAN 3 （10.1.3.0）， and the
management VLAN is on VLAN10 （10.1.10.0）. Hosts are able to ping each other but are unable toreach the servers. On the basis of the exhibited output， which configuration solution could rectifythe problem？（）
A.Enable IP routing on the switch D-SW1
B.Configure a default route that points toward network 200.1.1.0/24
C.Assign an IP address of 10.1.3.1/24 to VLAN3
D.Configure default gateways to IP address 10.1.2.1 on each host
E.Configure default gateways to IP address 10.1.10.1 on each host
F.Configure default gateways to IP address 200.1.1.2 on each host
Refer to the exhibit. Host A and Host B are connected to the Catalyst 3550 switch and have beenassigned to their respective VLANs. The rest of the 3550 configuration is the default configuration.Host A is able to ping its default gateway， 10.10.10.1， but is unable to ping Host B. Given theoutput displayed in the exhibit， which statement is true？（）
A.HSRP must be configured on SW1
B.A separate router is required to support interVLAN routing
C.Interface VLAN 10 must be configured on the SW1 switch
D.The global config command ip routing must be configured on the SW1 switch
E.VLANs 10 and 15 must be created in the VLAN database mode
F.VTP must be configured to support interVLAN routing
最新試題
Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed？（）
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.
Router NetworkTut is configured as shown below：Given the above configuration， which statement is true？（）
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password？（）
As a network engineer， do you know for what purpose SDM uses Security Device Event Exchange（SDEE）？（）
Match the xDSL type on the above to the most appropriate implementation on the below.
IPSec VPN is a widely-acknowledged solution for enterprise network. What are the four steps tosetup an IPsec VPN？（）
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）
Drag the DSL local loop topic on the left to the correct descriptions on the right.
Refer to the exhibit. Which two statements about the AAA configuration are true？（）