A. show frame-relay map
B. show frame-relay lmi
C. show inter serial
D. show frame-relay pvc
您可能感興趣的試卷
你可能感興趣的試題
A. B514:82C3:0029::EC7A:0000:EC72
B. B514:82C3:0029:EC7A:EC72
C. B514:82C3::0029:EC7A:0:EC72
D. B514:82C3::0029:EC7A:EC72
A. They run a spell check on host names to ensure accurate routing
B. They convert domain names into IP address
C. Given an IP address,they determine the name of the host that is sought
D. They map individual hosts to their specific IP addresses
A. VTP
B. 802.1Q
C. RSTP
D. STP
A. IR
B. DSSS
C. FHSS
D. DSSS and FHSS
E. IR, FHSS, and DSSS
A. It checks the configuration register
B. It attempts to boot from a TFTP server
C. It loads the first image file in flash memory
D. It inspects the configuration file in NVRAM for boot instructions
最新試題
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?（）
Which command is used to display the collection of OSPF link states?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?（）
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
How are VTP advertisements delivered to switches across the network?（）