A. The address is a broadcast address
B. The Ehernet interface is faulty
C. VLSM-capable routing protocols must be enable first on the router.
D. This address is a network address.
您可能感興趣的試卷
你可能感興趣的試題
A. lowest port MAC address
B. port priority number and MAC address.
C. VTP revision number
D. highest port priority number.
E. path cost
A. Enable VTP pruning
B. From privileged mode ,erase the startup configuration file,then reload.
C. From privileged mode ,erase the vlan date file, then reload.
D. Cycle the switch power.
A. FE08::280e:611:a:f14f:3d69
B. FE81::280f:512b:e14f:3d69
C. FE80::380e:611a:e14f:3d69
D. FEFE:0345:5f1b::e14d:3d69
A. 4094
B. 1024
C. 8190
D. 2046
E. 4096
A. RIPng
B. OSPFv3
C. static
D. IS-IS for IPv6
最新試題
How are VTP advertisements delivered to switches across the network?（）
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?（）
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）