多項選擇題Which of the following IP addresses can be assigned to the host devices?()

A.205.7.8.32/27
B.191.168.10.2/23
C.127.0.0.1
D.224.0.0.10
E.203.123.45.47/28
F.10.10.0.0/13


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題Identify the four valid IPv6 addresses.()

A.::
B.::192:168:0:1
C.2000::
D.2001:3452:4952:2837::
E.2002:c0a8:101::42
F.2003:dead:beef:4dad:23:46:bb:101

2.多項選擇題What are three IPv6 transition mechanisms?()

A. 6to4 tunneling
B. VPN tunneling
C. GRE tunneling
D. ISATAP tunneling
E. PPP tunneling
F. Teredo tunneling

3.多項選擇題Which two statements are true regarding EIGRP?()

A. Passiveroutes are in the process of being calculated by DUAL.
B. EIGRP supports VLSM, route summarization, and routing update authentication.
C. EIGRP exchanges full routing table information with neighboring routers with every update.
D. If the feasible successor has a higher advertised distance than the successor route, it becomes the primary route.
E. A query process is used to discover a replacement for a failed route if a feasible successor is not identified from the current routing information.

4.多項選擇題As a frame leaves a Layer 3 device, the Layer 2 encapsulation information is changed from what it was when it entered the device. For what two reasons can this happen?()

A. The data is moving from 10BASE-TX to 100BASE-TX.
B. The WAN encapsulation type has changed.
C. The data format has changed from analog to digital.
D. The source and destination hosts are in the same subnet.
E. The source and destination MAC addresses have changed.

5.多項選擇題For what two purposes does the Ethernet protocol use physical addresses?()

A. to uniquely identify devices at Layer 2
B. to allow communication with devices on a different network
C. to differentiate a Layer 2 frame from a Layer 3 packet
D. to establish a priority system to determine which device gets to transmit first
E. to allow communication between different devices on the same network
F. to allow detection of a remote device when its physical address is unknown

最新試題

Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()

題型:單項選擇題

Which statement describes the rule of split horizon?()

題型:單項選擇題

A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?()

題型:單項選擇題

An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?()

題型:單項選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型:單項選擇題

If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()

題型:單項選擇題

Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()

題型:單項選擇題

An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()

題型:單項選擇題

Which command is used to display the collection of OSPF link states?()

題型:單項選擇題

When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()

題型:單項選擇題