A. virtualization
B. unified I/O
C. support for 48-port Gb/s line card
D. support for Data Center Service Modules
E. high performance
F. high availability
您可能感興趣的試卷
你可能感興趣的試題
A. The bring up protocol automatically detects and overrides any misconfiguration.
B. You can manually configure channel groups， or they can be automatically created.
C. Changes in configuration to the SAN port channel interface must also be made to all members of the channel group.
D. The port channel protocol uses the exchange fabric parameters command to communicate across peer ports in an ISL.
E. The port channel protocol ensures that a set of ports is eligible to be part of the same SAN port channel.
A. The chassis needs an EPLD upgrade to support the new module type.
B. The default VDC cannot support F2 modules.
C. The interfaces must be allocated into a VDC for F2 modules only.
D. The module has failed GOLD diagnostics， and the switch has isolated the ports to protect the integrity of the system.
A. FabricPath provides MAC address scalability with conversational learning
B. Loop mitigation with TTL in the frame field
C. STPl independence
D. 10 Gbps bandwidth
E. Layer 2 extensions between data centers
最新試題
When will an "all configuration" backup be imported into the Cisco UCS Manager？（）
Where are SAN Port Channel is created in UCS Manager？（）
In the event of a GSS failure in a GSS cluster， which is true？（）
Refer to the exhibit. According to the equipment tab in Cisco UCS Manager， which is true？（）
In a Cisco Unified Computing System， What is the "designated receiver" port in end-host mode used for？（）
Refer to the exhibit.The Cisco UCS domain is operating in switching mode. A network administrator notices that no traffic is traversing the uplinks on Fabric Interconnect B （Path C）. Which actions might be used to change this behavior？（）
An administrator is creating a service profile but receives an error when applying to a blade. The administrator checks the faults tab of the service profile and finds the following error （Refer to the exhibit）.What is the cause of this error？（）
Given the following output： san-port-channel 12 is up Hardware is Fibre Channel Port WWN is 24：0c：00：0d：ec：d3：5c：00 Admin port mode is NP， trunk mode is on Port mode is NP Port vsan is 1 Speed is 8 Gbps Member[1] ： fc2/3 Member[2] ： fc2/4 What does "Speed is 8 Gbps" indicate？（）
What would be the cause for the following fault in UCS Manager？（） "ether VIF x / xxx down， reason： ENM source pinning failed"
Given a Cisco Unified Computing System， which is a valid port type in end-host mode？（）