A.RAM
B.NVRAM
C.flash memory
D.HTTP server
E.TFTP server
F.Telnet server
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit.Assuming that the entire network topology is shown, what is the operational status of the interfaces of R2 as indicated by the command output shown?()
A.One interface has a problem.
B.Two interfaces have problems.
C.The interfaces are functioning correctly.
D.The operational status of the interfaces cannot be determined from the output shown.
Refer to the exhibit.which address and mask combination a summary of the routes learned by EIGRP?()
A.192.168.25.0255.255.255.240
B.192.168.25.16255.255.255.252
C.192.168.25.0255.255.255.252
D.192.168.25.28255.255.255.240
E.192.168.25.16255.255.255.240
Refer to the exhibit. According to the routing table, where will the router send a packet destined for 10.1.5.65?()
A.10.1.1.2
B.10.1.2.2
C.10.1.3.3
D.10.1.4.4
A.enable cdp
B.cdp enable
C.cdp run
D.run cdp
Refer to the exhibit.Based on the exhibited routing table,how will packets from a host within the 192.168.10.192/26 LAN be forwarded to 192.168.10.1?()
A.TherouterwillforwardpacketsfromR3toR2toR1
B.TherouterwillforwardpacketsfromR3toR1
C.TherouterwillforwardpacketsfromR3toR1toR2
D.TherouterwillforwardpacketsfromR3toR2toR1ANDfromR3toR1
A.provides common view of entire topology
B.exchanges routing tables with neighbors
C.calculates shortest path
D.utilizes event-triggered updates
E.utilizes frequent periodic updates
A.120
B.100
C.90
D.110
Refer to the exhibit. A network administrator configures a new router and enters the copy startup-config running-config on the router. The network administrator powers down the router and sets it up at a remote location. When the router starts, it enter the system configuration dialog as shown. What is the caust of the problem?()
A.The network administrator faled to save the configuration.
B.The configuration register is set to 0x2100.
C.The boot system flash command is missing from the configuration.
D.The configuraiton register is set to 0x2102.
E.The router is configured with the boot system startup command.
A.It supports VLSM.
B.It is used to route between autonomous systems.
C.It confines network instability to one area of the network.
D.It increases routing overhead on the network.
E.It allows extensive control of routing updates.
F.It is simpler to configure than RIP v2.
A.hello packets
B.SAP messages sent by other routers
C.LSAs from other routers
D.beacons received on point-to-point links
E.routing tables received from other link-state routers
F.TTL packets from designated routers
最新試題
What parameter can be different on ports within an EtherChannel?()
Which one of these is a valid HSRP Virtual Mac Address?()
Which three are the components of SNMP? ()
Syslog was configured with a level 3 trap. Which 3 types of logs would be generated?()
What is the default Syslog facility level?()
Which three features are added in SNMPv3 over SNMPv2 ? ()
What level will be trapped if the administrator executes the command ?()
A network administrator creates a layer 3 EtherChannel, bundling four interfaces into channel group 1. On what interface is the IP address configured?()
What are the benefit of using Netflow?()
What are two benefits of using a single OSPF area network design?()