A.The IOS default is for a last-hop router to trigger a switch to the shortest path tree as soon as a new source is detected on the shared tree.
B.The IOS default is for every one of the routers on the shared tree to trigger a switch to the shortest path tree as soon as a new source is detected on the shared tree.
C.The default behavior of switching to the shortest path tree as soon as a new source is detected on the shared tree can be disabled by setting the value in the ip pim spt-threshold command to "infinity."
D.The default behavior of switching to the shortest path tree as soon as a new source is detected on the shared tree can be disabled by setting the value in the ip pim spt-threshold command to "zero."
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. In this network， R1 has been configured to advertise a summary route， 192.168.0.0/22， to R2. R2 has been configured to advertise a summary route， 192.168.0.0/21， to R1. Both routers have been configured to remove the discard route （the route to null created when a summary route is configured） by setting the administrative distance of the discard route to 255.What will happen if R1 receives a packet destined to 192.168.3.1？（）
A.The packet will loop between R1 and R2.
B.It is not possible to set the administrative distance on a summary to 255.
C.The packet will be forwarded to R2， where it will be routed to null0.
D.The packet will be dropped by R1， since there is no route to 192.168.3.1.
A.Multicast Source Discovery Protocol mesh-groups must be configured between the two anycast RPs.
B.The RPs must be within the same IGP domain.
C.Multicast Source Discovery Protocol must be configured between the two anycast RPs.
D.The two anycast RPs must be IBGP peers.
A.enable a Cisco router to "passively" listen to Auto-RP packets without the router actively sending or forwarding any of the packets
B.allow Auto-RP packets in groups 224.0.1.39 and 224.0.1.40 to be flooded in dense mode out interfaces configured with the ip pim sparse-mode command
C.enable the use of Auto-RP on a router
D.configure the router as an Auto-RP mapping agent
最新試題
Refer to the exhibit.What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown？（）
QoS機制中的分類，采用ip數據包中的哪個字段？
SPT初始狀態之后的一個狀態是什么？
當將多個交換機加入到MST region當中會發生什么（what happen）？
hsrp speak狀態是什么意思？
Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?（）
What is the next state of initial in spanning-tree protocol？
如何實現擁塞避免？
When upgrading the IOS image,the network administrator receives the exhibited error message.What could be the cause of this error?（）
What is the three main step of using the QoS feature with MQC command line interface？