A.Prepend extra AS hops to the BGP prefix.
B.Advertise more specific BGP prefixes (longer mask).
C.Add (prepend) one or more communities to the prefix that is advertised by BGP.
D.Have BGP dampen the prefix.
您可能感興趣的試卷
你可能感興趣的試題
A.On/On
B.On/Auto
C.Passive/Active
D.Desirable/Auto
E.Active/Active
F.Desirable/Desirable
A.The VLAN to instance mapping is a normal 16-byte field in the MST BPDU.
B.The VLAN to instance mapping is a normal 12-byte field in the MST BPDU.
C.The VLAN to instance mapping is a 16-byte MD5 signature field in the MST BPDU.
D.The VLAN to instance mapping is a 12-byte MD5 signature field in the MST BPDU.
A.lowest root bridge ID
B.lowest path cost to root bridge
C.lowest sender bridge ID
D.highest port ID
E.highest root bridge ID
F.highest path cost to root bridge
A.VTPv3 supports 8K VLANs.
B.VTPv3 supports private VLAN mapping.
C.VTPv3 allows for domain discovery.
D.VTPv3 uses a primary server concept to avoid configuration revision issues.
E.VTPv3 is not compatible with VTPv1 or VTPv2.
F.VTPv3 has a hidden password option.
A. interface bandwidth
B. interface delay
C. interface bandwidth and delay
D. hop count
E. bridge priority
最新試題
On the basis of the network provided in the exhibit, all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails, what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24, assuming that all the packets sent during convergence are transmitted once (there are no dropped or retransmitted packets)?()
Which two are differences between IGMPv2 and IGMPv3 reports?()
Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall?()
What is true about Unicast RPF in strict mode?()
What is the correct command to set the router ID for an OSPFv3 process?()
What is also called Type 0 authentication in OSPF on Cisco Routers?()
Which multicast address is reserved for cisco-rp-discovery?()
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message knowing that the MSDP router is also configured as an RP for the PIM domain?()
Based on the output provided in the exhibit, to which address or location will the router forward a packet sent to 192.168.32.1?()
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link,but only allow eachindividual flow to use 1 MB/s?()