Which statement best describes the relationships between AAA function and TACACS+， RADIUS based onthe exhibit shown？（）
A.TACACS+ - P4S1 and P4S4RADIUS - P4S2 and P4S3
B.TACACS+ - P4S2 and P4S4RADIUS - P4S1 and P4S3
C.TACACS+ - P4S1 and P4S3Actual RADIUS - P4S2 and P4S4
D.TACACS+ - P4S2 and P4S3RADIUS - P4S1 and P4S4
您可能感興趣的試卷
你可能感興趣的試題
A.Firmware-level virus detection
B.Signature-based virus filtering
C.Layer 4 virus detection
D.Signature-based spyware filtering
Given the exhibit below. You are a network manager of your company. You are reading your Syslog serverreports. On the basis of the Syslog message shown， which two descriptions are correct？（）
A.This is a normal system-generated information message and does not require further investigation.
B.Service timestamps have been globally enabled.
C.This message is unimportant and can be ignored.
D.This message is a level 5 notification message.
A.A copy of the frame is forwarded out all switch ports other than the port the frame was received on.
B.The frame is transmitted on the native VLAN.
C.The switch sends a NACK segment to the frame’s source MAC address.
D.The frame is dropped.
Which description is true about the show login command output displayed in the exhibit？（）
A.Three or more login requests have failed within the last 100 seconds.
B.When the router goes into quiet mode， any host is permitted to access the router via Telnet，actual SSH， and HTTP， since the quiet-mode access list has not been configured.
C.The login block-for command is configured to block login hosts for 93 seconds.
D.All logins from any sources are blocked for another 193 seconds.
A.Loopback interface
B.Command and control interface
C.Monitoring interface
D.Management interface
最新試題
Which two actions can be configured to allow traffic to traverse an interface when zone-based security isbeing employed？（）
What are two characteristics of the SDM Security Audit wizard？（）
Which two primary port authentication protocols are used with VSANs？（）
When using the Cisco SDM Quick Setup Siteto-Site VPN wizard， which three parameters do you configure？（）
When configuring SSH， which is the Cisco minimum recommended modulus value？（）
Which one of the Cisco IOS commands can be used to verify that either the Cisco IOS image， theconfiguration files，or both have been properly backed up and secured？（）
Which option ensures that data is not modified in transit？（）
Which information is stored in the stateful session flow table while using a stateful firewall？（）
Refer to the exhibit. You are the network security administrator responsible for router security.Your networkuses internal IP addressing according to RFC 1918 specifications.From the default rules shown，whichaccess control list would prevent IP address spoofing of these internal networks？（）
What is a static packet-filtering firewall used for ？（）