A.Switches take less time to process frames than hubs take.
B.Switches do not forward broadcasts.
C.Hubs can filter frames.
D.Using hubs can increase the amount of bandwidth available to hosts.
E.Switches increase the number of collision domains in the network.
您可能感興趣的試卷
你可能感興趣的試題
A.A successor route is used by EIGRP to forward traffic to a destination.
B.Successor routes are saved in the topology table to be used if the primary route fails.
C.Successor routes are flagged as "active" in the routing table.
D.A successor route may be backed up by a feasible successor route.
E.Successor routes are stored in the neighbor table following the discovery process.
A.Switch1（config-if）# switchport port-security maximum 1
B.Switch1（config）# mac-address-table secure
C.Switch1（config）# access-list 10 permit ip host
D.Switch1（config-if）# switchport port-security violation shutdown
E.Switch1（config-if）# ip access-group 10
A.It divides the network communication process into smaller and simpler components， thus aiding component development， design， and troubleshooting.
B.It enables equipment from different vendors to use the same electronic components， thus saving research and development funds.
C.It supports the evolution of multiple competing standards， and thus provides business opportunities for equipment manufacturers.
D.It encourages industry standardization by defining what functions occur at each layer of the model.
E.It provides a means by which changes in functionality in one layer require changes in other layers.
A.FTP
B.Telnet
C.SMTP
D.DNS
E.HTTP
F.POP3
A.console password
B.vty password
C.aux password
D.tty password
E.enable secret password
F.username password
最新試題
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?（）
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?（）
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?（）
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?（）
An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?（）
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?（）
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?（）