A.在二層唯一確定一臺設備
B.是設備在不同的網絡中通信
C.區別二層和三層幀
D.確定設備的優先級
E.是同一網絡的不同設備可以通信
F.當不知道遠程設備的物理地址時可以查詢
您可能感興趣的試卷
你可能感興趣的試題
A.RSTP cannot operate with PVST+.
B.RSTP defines new port roles.
C.RSTP defines no new port states.
D.RSTP is a proprietary implementation of IEEE 802.1D STP.
E.RSTP is compatible with the original IEEE 802.1D STP.
A.It checks the configuration register
B.It attempts to boot from a TFTP server
C.It loads the first image file in flash memory
D.It inspects the configuration file in NVRAM for boot instructions
A.ipv6 host
B.ipv6 unicast-routing
C.ipv6 local
D.ipv6 neighbor
A.Executing password recovery is required.
B.The virtual terminal lines are misconfigured.
C.Use Telnet to connect to RouterA and then to NewSwitch to correct the error.
D.Power cycle of NewSwitch will return it to a default configuration.
Refer to the exhibit.This command is executed on 2960Switch:
2960Switch(config)# mac-address-table static 0000.00aa.aaaa vlan 10 interface fa0/1
Which two of these statements correctly identify results of executing the command?()
A.Port security is implemented on the fa0/1 interface.
B.MAC address 0000.00aa.aaaa does not need to be learned by this switch.
C.Only MAC address 0000.00aa.aaaa can source frames on the fa0/1 segment.
D.Frames with a Layer 2 source address of 0000.00aa.aaaa will be forwarded out fa0/1.
E.MAC address 0000.00aa.aaaa will be listed in the MAC address table for interface fa0/1 only.
最新試題
傳輸層如何讓主機能同時針對不同應用程序維護多個通信流?()
PC 無法連接到任何遠程網站,無法ping 通其默認網關,也無法ping 通本地網段中工作正常的打印機。以下哪項操作可以確認此PC 上的TCP/IP 協議棧是否工作正常?()
請參見圖示。當計算機A 向計算機D 發送幀時,哪些計算機會接收該幀?()
請參見圖示。一臺路由器(其路由表如圖所示)收到發往192.168.1.4的數據包。路由器將如何處理該數據包?()
請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet。可以為路由器接口S0/0/0分配下列哪一個IP 地址?()
要將數據包發送到遠程網絡,應使用哪種設備?()
請參見圖示。主機B 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,San Francisco 器由器的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為10.10.1.2而目的IP 地址為10.31.1.20的數據包。捕獲該幀時,它的目的MAC 地址是什么?()
請參見圖示。從主機X 發出的到主機Y 的tracert 命令已成功。下列哪一項正確地反映了追蹤列表中顯示的中間網絡設備的順序?()
請參見圖示。主機X 和主機Y 與本地網絡的通信受到限制。此問題的原因是什么?()
何時必須使用clock rate 命令配置路由器串行接口?()