A.10Mbps
B.11Mbps
C.54Mbps
D.100Mbps
您可能感興趣的試卷
你可能感興趣的試題
A.The port is experiencing errors.
B.The port is administratively disabled.
C.The port is blocked by spanning tree.
D.The port has an active link with normal traffic activity.
A.127.0.0.1
B.172.16.0.1
C.192.168.0.5
D.223.0.0.1
E.224.0.0.5
F.254.255.255.255
In order to allow the establishment of a Telnet session with a router, which set of commands must be configured?（）
A.A
B.B
C.C
D.D
E.E
F.F
A.the session layer
B.the protocol layer
C.the data link layer
D.the access layer
E.the network layer
F.the application layer
A.amount of RAM
B.bridge priority
C.IOS version
D.IP address
E.MAC address
F.speed of the links
最新試題
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?（）
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）
What is the subnetwork address for a host with the IP address 201.100.5.68/28?（）
On which options are standard access list based?（）
Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?（）
Which command is used to display the collection of OSPF link states?（）
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）