A.hub
B.router
C.switch
D.STP
E.subinterfaces
F.VLAN
您可能感興趣的試卷
你可能感興趣的試題
A.This is a 10 Mb/s switch port.
B.This is a 100 Mb/s switch port.
C.This is an Ethernet port operating at half duplex.
D.This is an Ethernet port operating at full duplex.
E.This is a port on a network interface card in a PC
A.IR
B.DSSS
C.FHSS
D.DSSS and FHSS
E.IR, FHSS, and DSSS
A.ATM
B.IDS
C.IOS
D.IOX
E.IPS
F.SDM
A.Allow unrestricted access to the console or VTY ports.
B.Use a firewall to restrict access from the outside to the network devices.
C.Always use Telnet to access the device command line because its data is automatically encrypted.
D.Use SSH or another encrypted and authenticated transport to access device configurations.
E.Prevent the loss of passwords by disabling password encryption.
A.IP
B.ICMP
C.TCP
D.UDP
最新試題
Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
Which statement describes the rule of split horizon?（）
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?（）
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?（）
Three access ports have been installed and configured to a small office.What term defines the wireless topology?（）
What is the default administrative distance of OSPF?（）